Bp1048b2 Programming Verified -

Demonstrates how to integrate this feature into the main application loop.

#include "config_manager.h"
#include "logger.h" // Hypothetical logging
SystemConfig_t g_sys_config;
void setup() 
// Initialize Config Manager
Config_Init();
// Attempt to load existing config
if (Config_Load(&g_sys_config)) 
    Log_Info("Configuration loaded successfully.");
    Log_Info("Brightness: %d", g_sys_config.brightness);
 else 
    Log_Warning("Config load failed or invalid. Loading defaults.");
    Config_SetDefaults(&g_sys_config);
    // Save the defaults immediately so the flash is initialized
    Config_Save(&g_sys_config);
// Apply settings to hardware
Hardware_SetBrightness(g_sys_config.brightness);


void loop() 
// Example: User changes brightness via button/UI
if (Button_Pressed()) 
g_sys_config.brightness = 100; // User sets to max
    // Save the change immediately
    if (Config_Save(&g_sys_config)) 
        Log_Info("Settings saved.");
     else 
        Log_Error("Failed to save settings!");

This method allows you to verify the module is working and change parameters.

Step 1: Enter AT Mode

Step 2: Common AT Commands Send these commands via the Serial Terminal (ensure "New Line" / CR LF is enabled in your terminal settings). bp1048b2 programming verified

| Command | Function | Response | | :--- | :--- | :--- | | AT | Test connection | OK | | AT+NAME<name> | Change Bluetooth Name | OK | | AT+PIN<code> | Change Pairing PIN | OK | | AT+RESET | Reboot the module | OK |

If you are an OEM or a contract manufacturer requiring official verification: