Wittmann Tempro Plus D 360 Manual -
The very first section of the Wittmann Tempro Plus D 360 manual is devoted to safety. Ignoring these steps voids your warranty and risks injury.
Before diving into the manual’s procedural instructions, it is critical to understand what the D 360 model represents.
To access advanced settings (often required during initial setup): Wittmann Tempro Plus D 360 Manual
If your unit has the optional interface card (plug-in slot X45), the manual details the Modbus RTU register map. You can read actual temperature, setpoint, and error status directly to a PLC or MES system using these registers:
Daily:
Weekly:
Monthly:
| Interval | Action | |----------|--------| | Daily | Check for leaks at all hose connections. Inspect the sight glass for discoloration (rust indicates corrosion). | | Weekly | Clean the external air intake grille. Verify that cooling water outlet is not blocked. | | Monthly | Test the pressure relief valve by lifting the manual lever (wear protective gloves). Clean the Y-strainer on the cooling water inlet. | | Quarterly | Calibrate the flow meter using a bucket and stopwatch. Descale the pump housing if hard water is used. | | Annually | Replace pump mechanical seal (kit order no. 427.981). Replace contactors if cycle count > 500,000 (check in diagnostics menu). |
The back of the Wittmann Tempro Plus D 360 manual contains a mandatory maintenance log. The very first section of the Wittmann Tempro
| Frequency | Action | Reference Page | | :--- | :--- | :--- | | Daily | Check sight glass for flow & water clarity. | 12 | | Weekly | Clean the air intake filter (on the back of the cabinet). | 23 | | Monthly | Calibrate the temperature sensor. Insert a calibrated thermometer into the TCU's thermowell. Adjust offset in the service menu. | 67 | | Annually | Replace mechanical shaft seal on the pump. | 89 (Exploded view) |
Critical Manual Note: Do not use standard silicone sealant on the pump housing. The manual specifies Hylomar M or a PTFE-based gasket maker to prevent rubber swelling. Press "P" to cycle through parameters
