If your TS-1162 includes a stand:
Tecom TS1162 (also known as the 3 LED RAS) is a robust Remote Arming Station (RAS) designed for use with Challenger security systems. Rated
, it is suitable for both indoor and outdoor installations, including dusty or wet environments. Ness Corporation Mounting Instructions Disassemble the Unit
: Remove the two body retaining screws and set them aside. Pull the bottom of the body away from the base to disengage the top tabs. Prepare the Surface
: Use the mounting template to mark screw holes and the rear cable entry point. Ensure the surface is flat and vertical to prevent the base from warping when tightened. Secure the Base ts1162 installation manual exclusive
: If you require rear cable entry, cut a hole in the mounting surface. Use suitable screws to mount the base assembly, ensuring the tamper lever will be fully depressed once mounted to the wall. Reassemble
: Hook the top of the body back onto the mounting tabs, swing the bottom into place, and secure it with the original retaining screws. aritech.com.au Wiring & Connectivity LAN Connection : Connect the keypad directly to the Challenger RS-485 LAN . It can be positioned up to
from the main Challenger panel or Intelligent Access Controller. Power Caution
: Ensure all power is turned off to the Challenger panel before beginning any wiring. Additional Inputs includes a specific input for Request to Exit (RTE) If your TS-1162 includes a stand:
control and an open collector output for controlling door relays or strikes. Ness Corporation Addressing & Configuration DIP Switches : Use DIP switches 1 through 4 to set the unique RAS address LAN Termination
: If this unit is the last device on the LAN line, set the LAN termination using DIP switch 8 aritech.com.au Safety & Maintenance Environment
: The device is rated for high-durability environments but should still have roughly 25 mm of clearance from side walls or ceilings to allow for proper mounting and accessibility.
: Avoid using water, ketones, or aromatic solvents on the keypad surface. Use a soft, dry cloth or a small amount of isopropyl alcohol if necessary. logiqit.com.au Further Exploration Tecom TS1162 3 LED RAS - Ness Corporation Three-Point Support: Precision plates are designed to be
If your model includes the "i" suffix (TS1162i), connect the diagnostic lead to a laptop running firmware version 4.2.1 or higher. The exclusive handshake code is #TS1162-SYNC. A successful handshake returns the message: Rotor lock engaged – ready for zeroing. Any other message indicates a memory corruption that requires a factory reset.
Loosen the 12 o'clock bolt just enough to slide out the 0.05mm shim. Retighten that bolt to the original thermal pre-load value. You have now achieved true zero-gap contact.
This is where most installations fail. The ts1162 installation manual exclusive provides a "star grounding" topology that is non-negotiable.
The Exclusive Tip: The manual includes a diagram showing a 100-ohm resistor placed between Pin 2 and chassis ground only if you experience ground loop noise. Without this exclusive diagram, technicians often short the shield to Pin 2, causing catastrophic drift.
Using a calibrated torque wrench, tighten to 12 Nm. Pause for 10 seconds. Then tighten to 18 Nm in one smooth motion. The ts1162 installation manual exclusive includes a note: "Never use an impact driver. The piezoelectric crystal inside the TS1162 will fracture under impulse loading."