Samsung Clone S10 Lite Flash File: Mt6580 8.0
Look under the battery, in "About Phone," or use CPU-Z (install on the device) to find:
You likely need the Samsung Clone S10 Lite Flash File for one of the following reasons:
When flashing the Samsung Clone S10 Lite MT6580 8.0, you might encounter these errors:
| Error Code | Meaning | Solution | | :--- | :--- | :--- | | STATUS_BROM_CMD_SEND_DA_FAIL (0xC0060003) | USB driver issue | Reinstall MTK Drivers. Use USB 2.0 port, not USB 3.0. | | STATUS_EXT_RAM_EXCEPTION (0xC0050005) | Wrong preloader | Your firmware is for a different clone variant. Find the correct ROM. | | S_DL_GET_DRAM_SETTING_FAIL | Scatter file mismatch | The memory chip is different. Try a "Format All + Download" (risky, will lose IMEI). | | PMT changed for the ROM | Partition mismatch | Go to Options → General → Click "Legacy" DA Download. | | BROM ERROR: S_FT_ENABLE_DRAM_FAIL | Dead battery or bad preloader | Charge the battery externally. Use a different firmware version. |
Consider these backup options:
Samsung Clone S10 Lite (MT6580) is a replica device that uses a MediaTek MT6580 processor rather than the official Samsung chipset. To repair issues like boot loops, dead phones, or software hangs on this specific clone, you must use a dedicated MTK Flash File and tools like SP Flash Tool , as standard Samsung tools like will not work. Flash File Details MediaTek MT6580 Android Version:
8.0 (Oreo) – Note that many clones display "8.0" but may actually run on older versions like 5.1 or 6.0. File Format: Typically a "Scatter-based" firmware containing an Android_scatter.txt Required Tools & Drivers To successfully flash this device, you need the following: SP Flash Tool: The official Smart Phone Flash Tool developed by MediaTek for flashing firmware to MTK devices. MediaTek VCOM Drivers:
Critical for the computer to communicate with the device in "Preloader" mode while it is powered off. MTK Flash File: A verified firmware specifically for the S10 Lite clone. Flashing Instructions
The flashing process involves these standard steps for MT6580 devices: Preparation: Install the MTK USB Drivers and extract the firmware folder on your PC. Load Scatter: flash_tool.exe , click the "Choose" button next to Scatter-loading File , and select the Android_scatter.txt from your firmware folder. Selection: Ensure "Download Only" is selected. Samsung Clone S10 Lite Flash File MT6580 8.0
Avoid using "Format All + Download" as it may wipe your device's unique IMEI and calibration data. Initiate Flash: button in the tool. Connect Device:
Power off the phone completely. Connect it to the PC via USB. The tool should detect the device and start the progress bar (red, then yellow). Completion:
Wait for a "Download OK" green tick to appear before disconnecting the device. Recovery Options
If the device is still responsive, you can try a factory reset via Recovery Mode Look under the battery, in "About Phone," or
Follow this sequence precisely. Do not disconnect the phone during flashing.
To successfully flash this firmware, you need:
| Tool | Version | Purpose | | :--- | :--- | :--- | | SP Flash Tool | v5.1924 or newer | Flashing MediaTek chipsets. | | MTK USB Drivers | v1.0.5 (or Auto Installer) | Allows Windows to detect the phone in preloader mode. | | Windows 7/10 (64-bit) | N/A | Avoid Windows 11 for MT6580; driver signing issues occur. | | USB Cable | Data syncing capable | Cheap charge-only cables will fail. | | Battery | 50%+ | Clone phones often have removable batteries. Remove and reinsert to enter download mode. |